- Requirements
- Electrical Journeyman Courses
- 06 Limited Journeyman and Administrator Prep Course
- Commercial Load Calculations
- Conductors & Terminations
- Conduit Bending
- Design Bid of Electrical Systems
- Electrical Blueprint Reading
- Electrical Administrators Course for WA State Exam
- Electrical Journeyman Course for WA State Exam
- First Aid/AHA CPR & Electrical Basics
- Grounding and Bonding
- HVAC Administrator/Journeyman Review for the WA State Exam
- HVAC Basics
- Motor Control Basics
- NEC Calculations
- National Electric Code (NEC) Update
- NEC Update for 06, 06A and 06B
- Photovoltaic System Design & Installation
- RCW/WAC and Basic Electricity
- RCW/WAC & Basic Electrical Safety (NFPA 70E)
- RCW/WAC and Grounding & Bonding
- RCW/WAC & Intro. to Photovoltaic Systems
- RCW/WAC and Low Volt/Limited Energy Review
- RCW/WAC and NEC Load Calculations
- Residential Wiring
- Electrical Trainee Courses
- Conductors & Terminations for Trainees
- Electrical Administrator Course for the WA State Exam
- Electrical Journeyman Course for the WA State Exam
- Introduction to Electrical Theory
- Introduction to Electrical Theory for HVAC
- Introduction to Grounding & Bonding
- Introduction to the NEC and RCW/WAC Rules
- Introduction to NEC, RCW/WAC and Theory for HVAC
- Motors, Basic Controls and Hazardous Locations
- Plumbing Journeyman Courses
- Plumbing Trainee Courses
- Basic Hydronics for Plumbers/Pipe Fitters and Basic Hydronics Controls
- Industrial First Aid and Electrical Basics
- Journeyman Refresher Course for Plumbers
- Plumbing Code Update with Water Supply and DWV System Review
- Seattle Gas Piping
- Medical Gas Piping
- Solar Hot Water Systems and Basic Electrical Safety (NFPA 70E)
- Solar Hot Water Systems and Electrical Basics
- Online Plumbing Trainee Courses
- Online CEU Courses
- Classroom Course Refund/Transfer Policy
Conduit Bending 101
Course Description
Category 3 (8 hours Industry Related): This hands-on, lab-intensive course provides introduction to conduit bending methods, materials, and standards, including types of bends, required tools and equipment, and NEC regulations. Attendees practice bending in hands-on lab session. Conduit, benders and training materials included in cost of course.
Required Books/Materials: 2008 NEC Code book, pencil, paper, tape measure, calculator
